| Energy-efficient LED Ribbon Lighting |
|
lead free LEDs @ .5” [12mm] centres.
Colour: day light 5500-6500K
Operating temperature: Less than 30 °C
Estimated LED life: 100,000 hrs
Power supply: UL listed 12DC adapter
Power consumption: Up to 70% less than
traditional Fluorescent Lamp.
Lead and Mercury content: Zero.
IR and UV radiation: Nil.
Adhesive back.
|
| Real Dimensions |
1/4" [6mm] wide, Strip length 16' [5m] |
| LED Population |
390 pcs SMD LED’s with 1/2" [12.7mm] spacing |
| Beam angle |
120 degrees. |
| Maximum operating temperature |
50 degrees Celsius in free air. |
| Weight |
0.22KG / Roll |
| Power measured from 10mm distance. |
0.07W @ 12VDC = 23.5 watts 1.96 Amps / roll. Light output is 5500 lux |
| |
0.16W @ 12VDC = 38 watts 3.22 Amps / roll. Light output is 11500 lux |
| |
0.25W @ 12VDC = 44.6 watts 3.72 Amps / roll. Light output is 16000 lux |
LED Colour
|
Pure bright white 5500-6500K.
|
Assembly Information
- Solder connection should only be performed on designated solder pads (marked “=/-”). During soldering, don’t exceed the maximum soldering time of 10 seconds and the maximum soldering temperature of 260 degrees Celsius.
- The smallest unit, (3 LED’s) can be removed by cutting with scissors between the designated solder pads.
- The mounting of the ribbon is facilitated by means of the double-sided adhesive on the back surface of the ribbon. Care must be taken to provide a clean and dry mounting surface, free of oils or silicone coatings as well as dirt particles.
- The mounting substrate must have sufficient structural integrity. Take care to completely remove the adhesive backing. Once the ribbon is appropriately positioned, press on the ribbon with about 20N/cm2
pressure. (Refer to application techniques of 3M adhesive transfer tapes)
- The minimum bending radius is 2 cm. The ribbon may be bent over a smaller radius of the circuit board containing no electronic components. Such bends should be made once and fixed in position to avoid
cyclic fatigue.
|
