| BSHF-S350 Small single sided sign cabinet.
|
SIGNPRO BSHF-S350
is designed to be used with Singpro frames for flexible vinyl with a single bank of fluorescent lamps, or use any Singpro face frame back-lit with LED's.
BSH350 can be fitted with any one of over 14 different self-hinging
face frames for rigid plastic, flexible vinyl, or aluminum sheet applications.
This cabinet extrusion is ideal for small to medium illuminated signs and is used for a variety of applications including premise
identification, plaza and malls signage, institutional and public
facilities, parking signage, retail signage, wall mounted signs and
more.
|
|
|
 |
| Product dimensions |
L:
22'- 3" [6782 mm]
Custom lengths are available upon
request. Call for lead times and minimum order quantities.
|
| Fabrication dimensions |
H: Up to
4' before structural reinforcement is required |
| W: Limited to one lamp wide using fluorescent T12 illumination. (No standard lamp overlapping.) For LED illuminated cabinets, cabinet width is unlimited. |
| D: Overall depth vary depending on face
frame, see combinations. |
| F.S.: 2.78" |
| Painted Surface |
Exposed
surface area for painting = 3.623" [92 mm] x perimeter
|
| Classification |
Outdoor Indoor
Illuminated  Non-Illuminated
. |
|
|
 |
| Approved standards |
 |
|
| Wire management raceways |
Accommodates Signpro 1.75 " [44 mm] raceways using flush mount sockets.
Regular 4" [102 mm]
raceways bottoms and blank covers are used for horizontal sections of the
wire management system and houses the ballast with ballast brackets. |
|
 |
| Illumination |
Standard T12, T8 or T5 fluorescent tubes are placed at 8" [203mm] spacing for even illumination. Optional LED lighting to be installed as per manufacturer's specifications. |
|
|
 |
| Handling |
During
shop assembly, surface scratches can be avoided by the
application of protective masking tape.
DO NOT
lift extrusion carton with a sling at one point as this can cause excessive pressure and bend aluminum extrusion. Care should be taken to keep aluminum extrusion as straight, (flat) as possible.
DO NOT stand on extrusion.
|
 |
| Service access |
Hinge
open sign face by full retracting screws located along the bottom inner reveal of the
sign box.
Remove face frame completely by removing all hinging/locking screws from top and bottom reveal of sign and pulling frame straight out from sign cabinet.
|
| Face material access |
For SRT frame for flexible vinyl, remove face frame cover by retracting screws located on top, bottom & sides of the face frame cover. |
