| BSH2000 2" [51mm] Face frame for ACRYLIC or POLYCARBONATE |
SIGNPRO BSH2000 is our most widely used for Acrylic. It is an ideal choice for medium to large size illuminated signs. Radius corners are available in 6 " radius for this face frame.
BSH2000 is used for a variety of applications including premise identification, plazas and malls signage, institutional and public facilities, parking signage, retail signage, and wall-mounted and more. For strip plaza signage, BSH2000 can be segmented pre store using E-2070 2" H-Divider.
|
|
|
 |
| Product..dimensions |
L:
22'- 3" [6782 mm]
Custom lengths are available upon
request. Call for lead times and minimum order quantities. |
| Fabrication..dimensions |
H:
Up to 6'- 0" [1829 mm] |
| W:
Up to 31' - 6" [9601mm] before a customer made compresator may be required. See working with plastic. |
| D: Overall depth vary depending on
cabinet, see combinations. |
|
| Painted
Surface |
Exposed
surface area for painting = 5.145" [131 mm] x perimeter
|
| Graphic
face material |
Accommodates
3/16" [5mm] Acrylic or Polycarbonate |
| Classification |
Outdoor Indoor
Illuminated  Non-Illuminated
. |
| Approved
standards |
 |
|
|
 |
| Handling |
During
shop assembly, surface scratches can be avoided by the application of a protective masking tape.
DO NOT LIFT extrusion carton with a sling at one point as this can cause excessive presure and bend aluminum extrusion. Care should be taken to keep aluminum extrusion as straight, (flat) as possible. DO NOT stand on extrusion.
|
 |
| Service
access |
Hinge open sign face by fully retracting screws located along the bottom inner reveal channel of the
sign box .
Remove face frame completely by removing all hinging/locking screws from top and bottom reveal of sign and pulling frame straight out from sign cabinet.
|
| Face
material access |
Remove frame from cabinet. Remove assembly screw located on inside top & bottom of one frame end section, then pull frame section outward & remove. Plastic face can now be slid out of frame. |
