| E1700 Frameless Face Frame for 1/8" aluminum sheet |
| E1700 is designed to accept either stud welded or adhesive attached 1/8" aliminum sheet. This type of face is used for incised or push-through acrylic lettering.
E1700 is an ideal choice for small, medium or large size illuminated signs, and used for a variety of applications
including premise
identification, plaza and mall signage, pylon signs, institutional and public facilities,
parking signage, retail signage, wall-mounted signs and more.
|
|
|
 |
| Product..dimensions |
L:
22'- 3" [6782 mm]
Custom lengths are available upon
request. Call for lead times and minimum order quantities. |
| Fabrication..dimensions |
H: Up to 6'- 0"[1829 mm] |
| W: Up to 31'- 6" [9601mm ] |
| D: Overall depth vary depending on
cabinet, see combinations. |
|
| Painted
Surface |
Exposed
surface area for painting = 1.17" [30 mm] x perimeter |
| Graphic
face material |
Accommodates
1/8" [3 mm] aluminum sheet |
| Classification |
Outdoor Indoor
Illuminated  Non-Illuminated |
| Approved
standards |
 |
 |
| Handling |
During
shop assembly, surface scratches can be avoided by the application of a protective masking tape.
DO NOT LIFT extrusion carton with a sling at one point as this can cause excessive presure and bend aluminum extrusion. Care should be taken to keep aluminum extrusion as straight, (flat) as possible. DO NOT stand on extrusion.
|
 |
| Service
access |
Hinge open sign face by fully retracting screws located along the bottom inner reveal channel of the
sign box .
Remove face frame completely by removing all hinging/locking screws from top and bottom reveal of sign and pulling frame straight out from sign cabinet.
|
| Face
material access |
Remove frame from cabinet. Remove assembly screw located on inside top & bottom of one frame end section, then pull frame section outward & remove. Plastic face can now be slid out of frame. |
