| BSHD-W1300 Wide double sided sign cabinet. |
|
SIGNPRO BSHD-W1300 is our widest double-sided self-hinging cabinets designed for larger sign structures.
Wider
fillers are structurally stronger to withstand greater wind loads and
accommodate larger internal posts.
A selection of over 14 different self hinging
face frames for rigid plastic, flexible vinyl, aluminum sheet, or multi-panel applications.
Radius corners are also available for plastic faced signs and flexible vinyl faced signs. BSHD-W1300 is a main consideration for large vinyl faced applications, as the wider cabinet is a major factor for
reducing vinyl face frame bracing shadows and lamp hot spots.
DW (BSHD-W1300)
is used for a variety of applications including premises
identification, plazas and malls signage, institutional and public facilities,
parking signage, retail Signage, and more. |
|
|
|
 |
| Product dimensions |
L:
22'- 3" [6782 mm]
Custom lengths are available upon
request. Call for lead times and minimum order quantities.
|
| Fabrication dimensions |
H: Up to
10' [3048 mm] before structural reinforcement is required |
| W: Up to
8'- 4" [2540 mm] before structural reinforcement is required |
| D: Overall depth varies depending on face frame, see combinations.
|
| F.S.: 11.06" |
| Painted Surface |
Exposed
surface area = 12.682" [322 mm] x perimeter
|
| Classification |
Outdoor Indoor
Illuminated  Non-Illuminated
. |
|
. |
 |
| Approved
standards |
 |
|
| Wire
management raceways |
Available
with pre-punched socket holes @ 2" [51 mm] |
| Illumination |
Standard T12 fluorescent tubes are placed in cabinet centre at 12" [305mm] spacing for even illumination. Optional LED lighting to be installed as per manufacturer's specifications. |
|
. |
|
|
 |
| Handling |
During
shop assembly, surface scratches can be avoided by the application of protective masking tape.
DO NOT
lift extrusion carton with a sling at one point as this can cause excessive pressure and bend aluminum extrusion. Care should be taken to keep aluminum extrusion as straight, (flat) as possible.
DO NOT stand on extrusion. |
|
. |
 |
| Service
access |
Hinge
open sign face by full retracting screws located along the bottom inner reveal channel of the
sign box.
Remove face frame completely by removing all hinging/locking screws from top and bottom reveal of sign and pulling frame straight out from sign cabinet.
|
| Face
material access |
For SRT frame for flexible vinyl, remove face frame cover by retracting screws located on top, bottom & sides of the face frame cover. |
