Home > Signpro > Designing and specifying > BSH1100

BSH1100

BSH1100 hinge on hinge
See double sided cabinet features
BSH1100

C: This frame fits all self hinging cabinets
F: Main frame
FL: Face frame for plastic with clear Lens
B: 1104 corner bracket
S: 2107 frame cover and corner bracket screws
L: Lock strip. See BSH1100 Fabrication
P: 3/16" [5mm] plastic
G: 2105 weather seal gasket
A: 2106A Top hinging Bottom locking screw




 
   
BSH1100 Hinging on Hinging frame for Track-Letter faces
SIGNPRO BSH1100 is designed to hold a secondary acrylic face that be utilized to mount track letter system. It is used in conjunction with any Signpro cabinet extrusion and either BSH1250 or BSH2000 frames for acrylic. BSH1100 is used for a variety of applications requiring readographs including churches, schools, plazas and malls signage, institutional and public facilities.
Product..dimensions  L: 22'- 3" [6782 mm]
Custom lengths are available upon request. Call for lead times and minimum order quantities.
Fabrication..dimensions H: 6'- 0" [1829 mm]
W: Up to 31'- 6" [9601 mm]
D: Overall depth vary depending on cabinet, see combinations.
Painted Surface Exposed surface area for painting  =2.3" [58 mm] x perimeter
Graphic face material Accommodates 3/16" [5mm] Acrylic or Polycarbonate
Classification   Outdoor      Indoor       Illuminated       Non-Illuminated
.
Approved standards
Handling  During shop assembly, surface scratches can be avoided by the application of a protective masking tape.

DO NOT LIFT extrusion carton with a sling at one point as this can cause excessive presure and bend aluminum extrusion. Care should be taken to keep aluminum extrusion as straight, (flat) as possible. DO NOT stand on extrusion.

Service access Hinge open sign face by fully retracting screws located along the bottom inner reveal channel of the sign box .
Remove face frame completely by removing all hinging/locking screws from top and bottom reveal of sign and pulling frame straight out from sign cabinet.
Face material access Remove frame from cabinet. Remove assembly screw located on inside top & bottom of one frame end section, then pull frame section outward & remove. Plastic face can now be slid out of frame.

   
image